From Power Source:

1. White Connects to the white wire from the motor
2. Black connects to the black lead on the T-Stat.
3. Green connects to the green ground screw on the PT6 casing.

From Fan Motor:

1. Black (w/White Stripe) goes to the remaining black lead on the T-Stat.

Please email warrantyllbp@gaf.com for more information and wiring diagrams.

From Power Source:

1. White Connects to the white wire from the motor.
2. Black connects to one of the black leads on the T-Stat and one of the black leads of the H-Stat.
3. Green connects to the green ground screw on the PT6 and H1 casings.

From Fan Motor:

1. Black (w/White Stripe) goes to the remaining black leads on the T-Stat and H-Stat.

Please email warrantyllbp@gaf.com for more information and wiring diagrams.

The fan should be based on the attic square footage and amount of NFA Intake:

• 1600 sq. ft. or less - ERV4 - 1000 CFM

• 2200 sq. ft. or less - ERV5 - 1250 CFM

• 2800 sq. ft. or less - ERV6 - 1500 CFM

• 2300 sq. ft. or less - EGV5 - 1450 CFM

• 3000 sq. ft. or less - EGV6 - 1600 CFM

It is recommended to use 14 gauge wire under 50 ft. and to use 12 gauge wire over 50 ft.

Always check and follow local or state building codes.

CFM = Cubic Feet per Minute. In this case, it is the cubic feet of air that a fan will move in one minute.

NFA - Net Free Area. This is the actual open area of a vent which will allow air passage.

No, the fan is designed to be installed on an Asphalt Shingled roof, with a pitch between 3:12 and 12:12.

Master Flow® Replacement Motors, along with some available parts, can be purchased through Home Depot.

Some vibration may be caused by oversizing of attic fans. These would seem to "bounce" on the roof. Not having the required nails may also cause vibrations. There should ba a nail every 4" on the perimeter of the flashing. A damaged blade may result in an imbalance, thus promoting vibrations.

Master Flow® fans do not have a battery. These only work in direct sunlight.

Master Flow® need a copy of the receipt/serial number along with the homeowner's information and a description of the issue to start the warranty process. Send this information to warrantyllbp@gaf.com or mail to:

LL Building Products

Attn: Warranty Dept.

295 McKoy Rd.

Burgaw, NC 28425